![]() In this case it towards the rear (actually the front in Benbox) of the machine. I think the thing to remember with the motors is to put the contacts facing where the wires should be going. There’s three stepper motors, with four holes each that means there twelve screws. You just gotta use the power of deduction to work out which machine screws fit on which part of the machine. I think they are NEMA17 motors and I’m going to screw these on now. Ok all the fixings are supplied in this packed lunch box. ![]() I’m guessing these are the sides, the gantry, this is possibly to hold the controller. And they have a protective coating on them, in the form of this brown paper which actually looks quite nice. They have also been cut on a laser cutter. And based on those two I think I can sorta work out what to do. One sounded like it was in Portugese and another one which had really bad music on it. In any case I did a bit of research and found two videos online. Ok so I’m going to assemble this mini laser engraver and er, there’s no instruction in the actual packaging. “Please don’t the eye! When using must wear goggles!” In this video I am going to assemble an Eleks Maker 2500mw A5 Mini Laser Engraving Machine which was sent to me from GearBest.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |